i have just got a igo8 with wince6 and i was wondering if i can put navteq maps on it
its running 8,3,4,14 7"screen says it was built may 11/2010
any help or point me in right direction
many thanks

Hi guys
I still have an on-going problem with Primo 2.4 I have a Chinese 800x480 unit and my preferred cockpit layout is the alternate 2. When I select it from the menu, it restarts and I get the following error message. Failed to open file ui_igo9\800_480\ui\\cockpit2.css exiting application. On investigation in the data file I have found that the file requested is missing. I messed around trying to use data files from previous versions ...

Hi all,

I am running Primo 2.4 & have troubles with loading schemes/skins.
When I go into setup/map display & change day or night colours I gat the error - Cannot find 'ui_igo8/common/trackinglist.spr'

What is causing this?
How do I correct?
What setting do I need?

I have the standard '.zip' files in content/schemes etc.

Thanks

Yesterday, while driving and I was very close to my destination in an industrial zone, I got a popup saying "This route requires a special permit" or something similar which I cannot recall. The popup window had an OK button below the message, but when I clicked on it nothing happened. So, with this popup blocking the screen, the GPS was practically not functional. I do not know what would have happened if I had ...

Hi

I seem to be getting an intermittent issue where occasionally IGO Primo 2.0 looses the GPS signal for no apparent reason. Sometimes it comes back quite quickly and sometimes it doesn't even after a reboot. It is NOT an issue with satellite visibility as there is nothing blocking the receiver on the dash and it is clear blue sky.

Any ideas welcome, I know some have some settings in their sys.txt file but as ...

I am running iGO Primo 2 & whenever I load up a route, I have an panel on the right hand side of the screen showing 'green' items, fuel, CO2 etc. I am not using these, how can I get rid of them from the screen permanently.
Can I change colours of the maps? How?

Thanks.

Hi. I have searched everywhere for this. I have a DDin 8" wince 6 car navigation system (800x480)and I have installed primo which works great (thanks). I have set the systems screensaver for 2 minutes and it shows an analog clock.
Question: Is is possible to change this to a large basic analog or digital speedometer (kph)?
Thanks.

Hi All,

I have created some routes useing TYRE (Trace Your Route Everywhere) & saved them as .KML files.
How do I now read them on my Peaklife GPS using Primo2?

Thanks.

Hi, all
I want to know how to change sys.txt file and my igo on internal memory to read maps put on the sd card? Is it possible to put everything, poi,speedcam , builging ,etc... on internal memory, and put only maps on the SD card.Because i try with this sys.txt:


;app="User/MobileNavigator"
map="SDMMC\map"

and igo run, but it show that is no map on the folder:(

Does anyone know if building file(s) exist for North Carolina USA? I can find only 3dl files, would like to have 3dc if it exists.