Hello,

So the other day, I tried to load iGo Primo and it wasn't playing ball. I've used it for months without an issue and perhaps I've abused it a bit (hard shutoffs etc). As soon as the software started to load, the error appeared. The particular error I got was a memory access violation. Anyway, I've never had too many issues with iGo but I've always been told if it stops working deleting the ...

I have another gps working with igo primo with no problem but i can't figure out with this one, any help with be appreciated.
Thanks.

Hi,
I have a MYGuide MG3218 that I want to update to IGO however all the data is stored on the internal rom that I have to acces via windows (sync) mobile app

it has a Computer\WindowsCE\ResidentFlash folder with MobileNavigator on it


I have found info of how to install IGO on the MYGuide that uses the SD to store all the data
https://forums.ebuyer.com/showthread.php/11402-125129-MyGuide-3100-Series-Sat-Nav-Unit?p=367295#post367295

however not for this device, it does have the SD slot ...

hiya all
keep getting the above error when selecting destination from history, tried updating cfg file with latest one available but still same, happens with all maps (tried 2011, 2012, 2013), tried original poi pack and full poi pack, all files used off here from primo 2.4 (9.6.13.267029) to maps so nothing I use is from another source.
also, realtime route alternatives when offered crashes programme if select preview.

any suggestions/solutions?

thanks in advance

HI ,
I have successfully installed IGo Primo2 with Maps and Speed cameras for the UK and it's great however
I have speed limits on as permanent and the warning set at 10% that works great however the speed shown
in the bottom left corner just below the percentage of the speed limit is in KMPH !

does anyone know how to set this to MPH ?

everywhere else it shows up as MPH

Thanks ...

Hi, Help please.

Primo 2.4 but i think will be the same thing on all primo's?

I want to make the arrow smaller, about half the size. I have done it in the 3D mode with the help of a very nice man on here but it does not reduce the size in 2D mode which is what i prefer to use. These are the lines for 3D and then play around with the numbers ...

Hidden Content

This board requires you to be registered and logged-in to view hidden content.

Hi everyone,

Please I need a help from someone who know how to well install speedcam in IGO primo2, for car GPS ( running in SD CARD).

I have installed the IGO PRIMO 2 (iGo-Primo 2.4-9.6.13 Complete), and everything works well.

then now I tried to install a speedcam, for my country, as explain here:
http://www.navitotal.com/general-discussions-about-tomtom-f81/tomtom-official-speedcams-2014-t6933.html

- to avoid errors, i have copied and pasted desired file within map AND speedmap folder. Then I installed ...

Hello, I'm new to this forum and am a complete novice with Nav software. I have purchased a Chinavision 4.3" Motorcycle Sat Nav which has the following spec:
Win CE6.0
128MB
480x272
4GB internal + Micro SD
No GPS software

I think I should load IGO 8 for europe, but advice from you guys would be really appreciated.
Can anyone help me?

Hello my friends!

This is actually my first time in this forum and I see you guys are cool!
Unfortunately, I am having a little problem setting up my iGo Primo2 running on a Wince 6 Dvd Car device. (Double Din)

So, I Installed it normally and it's running perfect, but when I go to maps there's this "black backgound" "No maps" only the blue GPS arrow on position. Even though shows me the longitude ...