can the ezy and my series navman be unlocked and run igo?

also the traffic feature? does igo utilize that? is the traffic thing built into the car charger of the navman? so it wont work if I use a different charger?


happy holidays :)

In my garmin it used to say you have arrrived at "8 example street" on the left, it basically said the address of the destination when you arrived at it, however on my igo it just says you will arrive at destination in 200 yards on right. It does not say the address you arrived at.

How can I make my igo say this?
I have a 9. primo version with TTS voices.

The One big negative to this chinese double din with WinCE is that I have to switch completely out of navigation mode to run music via bluetooth. If there a way to stream music and have GPS.

Hi. I am in a need of a little help I have purchase the latest igo primo on my iPhone southern Africa and I have purchased all the add ons speed cam etc. my device Is jail broken.
Can I get the maps,speed cams, licenses etc from my iPhone and copy it my sd card for my car head unit my head unit does 800x600.
Ay suggestions

Hi I have igo maps running on Blaupunkt TravelPilot Lucca 3.3 but I cant find satellite I have played with system text setting gps to Auto and setting gps to port 2 gps 4800 and still no satellite. Any help would be great thanks

I was using the Map set Australia NQ 2013.Q2 and added Australia WhereiS R20.2 Telstra 2013.Q3 , I just added the new files and kept the old ones also.
I noticed that after this my speed camera warnings stopped. I remember reading somewhere on here that TTS only works with Navteq (NQ) maps, I searched the form for info on this but came up short. Is this why the speed cameras stopped working or ...

I have the following igo inatstalled

http://gpsunderground.com/forum/igo-models-listing/22900-igo-primo-truck-2013-%40-europe-full-speedcams-tmc.html

I have noticed when it shows destination/arrival time it is way more than it should be.

Example:
Miles to destination is 3 miles. but arrival time is 0.45

it only takes around 5 or 10 mins max to get to destination sho why does the estimated time exceed this is a vast way. Is there a fix for this?

I am using navteq maps and the correct timings ...

The software routes fine when in truck mode but it does not seem to show any low bridges, width or weight icons on its maps. Is there a way to get these to show on igo? if so how do I go about this

I have igo version 9.6.5.278914 and latest navteq maps installed.

Says can't find that bmp file. I get this error in certain areas and pressing OK crashes the software. This is probably some poi detail issue. How to fix it? I am running 2012 Q4 maps and poi.

Hi everyone,

I am using Primo 2 with the Dimka skin, and when I set a route with waypoints, it used to show yellow flags for each waypoint as you approached them. Now, for some reason, they have disappeared meaning I have to keep more of an eye on the sat nav as I approach one.

Any ideas why?

Regards

Bangerdemon