Ok, I hate to ask but I have searched and tried several solutions posted on the forums and have ran out of ideas so here are the details.

I have the above device..
It is running Route66 Uk and Ireland 2009 Q4.
It is using Navteq maps.

I would like to run the Igo Primo2 core and maps I have on my BinatoneF430 and have saved all the files,folders and Shell.ini to another SD card. ...

Although I now provided a few Truck editions suitable for 2GB devices, it might be time to hand the work over to everyone that needs the map faster or with other modificatios.
Since the procedure is pretty straight forward I will just sum it up in a few easy steps.

Before you start:
Make sure you have the complete Truck map and of course that a meta code is available.
You also need a full ...

Hi,

Trying to install Primo 2.4 from this link http://www.navitotal.com/showthread.php?14875-Primo-2-4-%289-6-29-341779%29-ANS-for-Android-25-Oct-2013

But need resolution for 1440 x 790 ( Tesco Hudl )

Any pointers a config for this?

Thanks

Hi,
I was just wondering if its possible to use the new 920 maps on Android as they dont seem to be listed on the chart. If yes, then what is the best version to use and how do I go about getting it to work?

Thanks.

Hi all im new here and looking for some advice.

Have a tomtom xxl and heard I could update maps etc by patching instead of having my pants taken down by tomtom everytime.

I have used patches before on other programmes and jailbroke iphone etc and am not totally stupid but didn't want to do anything that screws the device up.

Can anyone give me the simple steps or point me in the direction of ...

Is it possible to edit the .ftr file?
I have been along some roads that are limited in weights and heights and also width restrictions that are not listed on the file
It would be good to edit the file so I can add these new restrictions manually so the software can reroute me properly next time I may encounter same route

I have installed the latest igo primo software onto my old mio gps and everything works fine except one thing and thats the voice.
When i go into sounds/voices they all show up and when you click on them the tts speak and also the non tts also speak.
I have programmed in a route and the route summary is read out if I have chosen a tts voice.
However, when i drive with the ...

Since having a backup can save you a lot of trouble I'd like to make a recommendation I found in the freeware section:

Holo Backup

This little gem not only creates a backup of all your apps but it does not need any rooting to do this!
Please check the developers homepage for downloads and the very simple instructions.

6045
Roadnavi NL-G380M with asiagis Map

Is there anyone using this with Panasonic head unit ? Will it possible to have other map software install on it?

I just updated to Android 4.4 and noticed Tomtom stopped working.
Same when I try a fresh install, the program pops open and closes without any error message.
Not sure if it is related to updating or if there is a general problem with Kitkat, can anyone confirm or deny these problems?