Hi ,

I'd like to upgrade this device with the latest map of europe and safety cams .Could someone can explain to me step by step how to proceed ?
I saw that there are 2GB on internal memory and also a slot card...

Thanks in advance

Okej, so i have this Navman GPS with WinCE4.2 and whant to put igo on it.
I take igo 8.3 and put in in SD card and the SD card in the GPS.

What next?

Becouse when i start the gps lika that, nothing happens, and i have posted in ten forums and nobody helps me :(

Visual unlock for Becker Traffic Assist Highspeed II:



features:

* run original Becker software or iGo Primo
* Total Commander
* Day/Night schemes
* set Moodlight


Instalation instructions:

* connect your Becker via ActiveSync to PC
* Rename \My Flash Disk\Shell.exe to ShellB.exe
* extract archive
* copy archive (without the 1st level folder) to flash disk
* that's it! (switch off and back on)

download: http://rapidshare.com/files/426737476/visual_GPS_Becker_v101.rar

mirror: http://www.megaupload.com/?d=HCYDV0BD


D.

ok its nothing to do with iGO but,

i thought that it still concerns iGO users in a way because,

iGO runs on WinCE :P

So here's my question,

anybody can share with me their TCPMP ?

cuz im not sure if need codecs and skins and,,, i dunno....

anyone uses it?

hi i am looking for the latest navteq uk map for igo 8.3,is there a download for just the uk map or do i have to download the full europe?? if there is a separate link for just the uk after much looking i cant find it ,thanks.

PRIMO + 5" 800x480 Android Phone --> http://www.youtube.com/watch?v=BxjKonfd5oE&NR=1

thats nice :P

Although i doubt it,

i wonder if routing is better than the WinCE version,,,

I bought 1370T from Taiwan, firmware V2.90, and install mainland map 2010.30 on 4G SD, with SW.UNL & GMAPSUPP.UNL created with Jetmouse tools V1.5, the map works fine, with QSI function.

Recently, after I upgrade firmware to V3.1, even the map information showing in system normally with check mark (both mainland 2010.30 & Taiwan 2010.30), but the QSI icon (function) missing, and when I try to search mainland address, "no information" pop up.

I also ...

All,

I'm not so sure where i got this exe already but, recently i found out this weird thingy.

Previously i run X5SE, what i can see at advanve settings>software version> papago X5.2 Mar 12 which this is the last update from M3. But recently i run another X5.exe and it show software version>papago X6.2 Jun 20.....

look at this link here for those how want to try out.... already unlock for C14800.

I have unlocked and installed the safety cameras in to Garmin following the instructions provided, and when I near a safety camera I get a message that flags up in the centre of the screen that warns me of this. However, on the map there is no icon to represent it, is this normal? if not can you please advise how I can install cameras with an actual icon?

Should the safety cameras be showing ...

It is a rather fuzzy memory for me, but I seem to remember that in the old NavCore 8.083 (9669/090817) the display would automatically switch to Night Colors at some time, and back to Day Colors during the day. Or am I dreaming?

How do you enable this feature in NavCore 9.205.547817? I couldn't find any related info in the forum... Is it just wishful thinking?:pray:

Thank you in advance.

~lum