News of General Discussions about iGO core - Page 48

Next month I'm about to visit Croatia and Slovenia.
From your experience as residents or tourists, maps (and poi's) of which provider (HERE / TomTom) will give better and more accurate navigation?
And extra question, what app works better in this countries, iGO or Primo (with the recommended map)?

Thanks for you input.

Let me start with saying that any help will be greatly appreciated...

I have an old Mio c310X that I have not used in sometime. It has MioMap 3.2 installed on the internal flash and I have a unlock SD card that contains Miomap 3.3 with 2007 maps. I would like to at least be able to update the maps so my son would be able to use this for Geocaching, or even for resale ...

I have downloaded a Primo 2 prog and installed it in a newly acquired Chinese 2 din unit and all seems to be working well except that the prog has minimal function .... only the basemap, a default scheme, and no skins, not even a skin folder in contents.

My question is can I update this essentially bare Primo with maps, schemes, skins etc with the same elements from a working IGO8 version of the ...

Thanks to a now unknown member who sent this to me. You might enjoy it.

Hidden Content

This board requires you to be registered and logged-in to view hidden content.

Hi all.

Does anyone know how to change the colour of the day & night route colour (not the day/night skin itself)

At the moment, when I find a destination and press Go!, the day route colour to the destination is green. I would like to change it to red if possible.

Thanks in advance.

Ray.

Hello,

So the other day, I tried to load iGo Primo and it wasn't playing ball. I've used it for months without an issue and perhaps I've abused it a bit (hard shutoffs etc). As soon as the software started to load, the error appeared. The particular error I got was a memory access violation. Anyway, I've never had too many issues with iGo but I've always been told if it stops working deleting the ...

I have another gps working with igo primo with no problem but i can't figure out with this one, any help with be appreciated.
Thanks.

Hi,
I have a MYGuide MG3218 that I want to update to IGO however all the data is stored on the internal rom that I have to acces via windows (sync) mobile app

it has a Computer\WindowsCE\ResidentFlash folder with MobileNavigator on it


I have found info of how to install IGO on the MYGuide that uses the SD to store all the data
https://forums.ebuyer.com/showthread.php/11402-125129-MyGuide-3100-Series-Sat-Nav-Unit?p=367295#post367295

however not for this device, it does have the SD slot ...

hiya all
keep getting the above error when selecting destination from history, tried updating cfg file with latest one available but still same, happens with all maps (tried 2011, 2012, 2013), tried original poi pack and full poi pack, all files used off here from primo 2.4 (9.6.13.267029) to maps so nothing I use is from another source.
also, realtime route alternatives when offered crashes programme if select preview.

any suggestions/solutions?

thanks in advance

HI ,
I have successfully installed IGo Primo2 with Maps and Speed cameras for the UK and it's great however
I have speed limits on as permanent and the warning set at 10% that works great however the speed shown
in the bottom left corner just below the percentage of the speed limit is in KMPH !

does anyone know how to set this to MPH ?

everywhere else it shows up as MPH

Thanks ...