Hi everyone and particular thanks to those guys who have put so much work into getting Primo available to us.

I run my IGO8 from the SD card on my C320b. (XTyler's unlock)

Recently I have, more by accident than by knowing exactly what to do, got Primo working on my device. I launch the device by doing a soft restart (3 flashes on the power light), then when Mio starts I briefly press the ...

After using iGo 8 for several years, I switched to Primo last week and the best feature so far is its ability to survive sleep. I have a Mio C320 and when you wake the device from sleep, iGo used to show up and then reboot. That took a while every time you started the device. iGo was still a very responsive software. But the restart was annoying.

In Primo, they seem to have "fixed" ...

Should both *.hnr and *.fbl files be in the iGO/content/map folder of iGO Primo and if so, how does iGO Primo select one or another ?

Hello everbody,

my question is next, if somebody has expirience with this thing, i want to change my route in IGO8.3 - 3 november version to another one than one application suggest me...

Exactlier i want to use option INSER VIA, to add some another city on suggested route, to change route manually, cause for region where i want to travel, igo suggest me some route which isn't ok for me!

When i try to ...

Hi All,

Believe it or not, speed cameras are new to me. Actually it was my first try this morning. I am a bit confused though. Here is my issue. When I drive on the highway here in Belgium, it happens very often that Igo will warn that there is a speed camera even though it is on the street that goes under the highway. That speed camera is not for the highway... And of ...

I have my current GPS set up so that when I turn it on it loads directly into Igo8.3.2. I am using the standard stock skin and do not want to change it. The problem is that if I use the exit button the unit freezes. I can exit with the external power button but I would like to disable the the program exit button on the lower right hand side of the screen to ...

Just installed iGO Primo on my mio moov 500 and it looks great.
Only if I start up, I get the message that my device does not match the one that is selected in a list and asks if I want to choose another device. In the list there is no mio moov 500, so I choose another with the same specs. Then I got the message that there is a gapi device mismatch. If ...

Hi every bothy
May by can hepl me
I have gps car NavNgo IGO 8 8.3.2.93112, but first time when I start it takes too long20-30 min time to fine the position, and after it is go fine
What wrong ca be?
Manny Thanks

Otty:mad:

I was looking to get an answer to my problem but I can't find an answer about my problem. I installed IGo Primo and everything is loaded but when I try to set a trip I got stuck on Autodetecting GPS receiver and there is no satellite found. Can anyone help me to solve this? Thank you very much.

I have a Chinese navigator with WinCE 6.0 and the initiation of the first Igo, or Amigo or Becker Version screen appears in Annex I, and I normally use to select the second item and give ok.
Someone can give me an explanation?
Thank you.