Hi. I have a problem, I installed igo primo on a Samsung tablet running perfectly, change the path to the file "sys" putting:


app = "/ storage / extSdCard / iGO"

to boot from the SD card, and works well, except KML files that get into userdata / poi I do not read. Please ask for help. Greetings.

helle there,
i"m newbie....
yesterday, i decide to to make a second life for my MIO 200 buy in 2008 !
and it is ok now.......i'm so happy, he run with IGO 8 with .fbl 2016 French ^_^

but, i have not voice .FR (french) on it.....

and i don't no what and where put a TOMTOM French map on my sdcard (<1GB)

i have fastactivate and his tutoriel

can someone talk me for finish ...

Dear community,

When I define a route, e.g. from Paris to London, IGO shows the remaining time to destination.
My question is:

Is there a way (sys.txt) to force a faster update of the remaining time?

When I start the trip, it showns me for instance, 3:45 hours to destination, when on reality during the trip it is updating (very slowly) the remaining time.

On highway I normally drive at 155 km/Hour (146 km/hour on ...

Dear community,

I have a 2015 VW Golf MK 7 with composition media version 1, connected to an internal device - Dynavin - (retrofitted by VW dealer)

Dynavin

That allows me to have Igo Primo running in the same screen (The media is OE from VW but there is a device inside the dashboard, connected to the screen of the media). To activate Wince / IGO, I have to press the "Media" button for 3 ...

I have a magellan 9212 7" gps with tmc. I have loaded primo 2.4 and happy with it. My problem is I cannot find a way to get primo or igo to see the onboard tmc. I know from some research that the tmc is on port 1 baud rate of 57600 and something on com1: SW_TMC (S3c64xx_SW_TMC). I have tried several sys.txt but to no avail. I m hoping someone out there has solved ...

I can barely here it when it comes on, I have it set to the max in volume settings.
Is there something I need to add or do with the sys.txt file to be louder?

Ok guys, I have tried everything I can think of, but to no avail. I want to change the loading bmp on my igo8 gps. I have created the bmp with 800_480 24 bit. When I try to run igo, I get an error cannot open ui_igo8\loading.bmp file. I have read some old post but it did not help. I was hoping someone might have a secret way to get it done.

Also another problem ...

Hi I've just downloaded a new navteq map for IGO could you tell me where the files FDS FJV and FJW I have never seen these before also could you tell me where Extended Pois and truck pois go please.
Thank you.

Hey,

I have my device Becker active 43 talk,
I have tried many IGO8 versions out here, and non of them is working with me.
(Some had "inserd SD card" issue, and some just got stuck on launch screen rebooting)
The version i have currently is 8.5.12.xxxx
(i just need "cracked" one so i can use the latest maps out there)

My question is: Does someone know what i should use, version etc. and any ...

Does Anyone Have The Latest IGO Primo USA Traffic Camera Location Data File. I Tried The Ones That Are Suggested On This Site. But They Seem To Be Dead Download Locations.

Much Appreciated If Anyone Has The Latest One.