Run iGO Primo 2.0 on Mio Moov and Navman S series (and some

If you read the guide there is a section about making shortcuts for the desktop and automatically starting the software

And a few posts up from here is the answer and fix to the off button problem

Hi Fatboyfun,

I'm trying this out on my S35 just to see if it works. I already have TomTom working from the other thread.

I'm using the optimized version of iGO Primo from the first post. I'm using the .fbl from the Aus R19 map and nothing else.

When I open the map from within iGO I get the following error:

"Failed to open file: - map_housenumber_bg @130x28.bmp"

Any ideas?

Yes!

Make a small edit to the data.zip using winrar (Don't unzip!!!)

COPY the data.zip to your PC and make a copy just in case!
In the data.zip there is a ui_igo9 folder, Within this folder are resolution folders, ie 320_240, 480_272 etc
Copy the file map_housenumber_bg to the 320_240 folder (Don't Unzip!) You will need to copy the same file from the skin_night folder to the other resolution skin night folder as well
Allow Winrar to update the archive, and copy back to your device and try again.

Fatboyfun wrote:If you read the guide there is a section about making shortcuts for the desktop and automatically starting the software

And a few posts up from here is the answer and fix to the off button problem

Thank you, it is done!

I'm going to update this to primo 2.0 soon

Fatboyfun wrote:Yes!

Make a small edit to the data.zip...

OK I'll give it a try and post the results.

Fatboyfun wrote:I'm going to update this to primo 2.0 soon

I'm already using it, since a couple hours ago. Pretty good i must say, a few new feactures here and there. But basicaly it is the same lik this one here.
And its the same steps too!

Fatboyfun wrote:Yes!

Make a small edit to the data.zip using winrar (Don't unzip!!!)

Fixed...

Works a treat.

Thanks Fatboyfun (again)

Thanks for the update :)

Bump! Updated to Primo 2.0!

Hi guys

I decided to go a slightly different way and use VisualGPS to unlock a Mio Spirit 480. It's all up and running but I cant figure out how to instal Primo on it. Can you give me a step-by-step please?

Thanks heaps

Start from step four, you will need to set up a button to point to the primo executable, see the visual instructions on how to do that...

Hi all,
I have a Mio Navman 470 {Windows CE 5.0, No SD card}}
I've already downloaded IGO Primo 2.0 but i'm struggling to find the correct map.
I'm looking for UK/ROI etc as i only have around 1.5GB of free space.
Could someone kindly post a link?
BTW, great forum!

Rocketron wrote:I'm looking for UK/ROI etc as i only have around 1.5GB of free space.

Here, perhaps?
:link:

Yurbuh Tuggly wrote:Here, perhaps?
:link:

Thanks,
I tried to PM him but his inbox is full, nevermind...

:-)