Hi! I need licenses files for becker 43 for maps and poi for all europe please!

One important question: Official Becker device and program or not?
Software and license are a combination. Official program = official license. "Cured" progarm = "cured" license.
When you downloaded a cured program, the license should be part of it.

I have a "cured" 8.5.12.204002 exe file

Maps and POI you will find in our iGO maps section.

When you downloaded the cured becker igo, the license should be included.
I include in attachment the Becker Z215 license (Becker 43/igo 8.5.12.165600.

Unrar and copy in the license folder.

nabi,
wondered if you could help with this one, Ive installed onto sd card Navteq 2014 Q1 as per instructions on forum, all loaded and then told me with a pop up 'Map initialisation error' cannot open the map files with your Licence !
Im using genuine iGo software on my Becker Active 43 Transit.
thanks in advance for any help and Info.

You can't use maps from here, or similar site with a genuine copy of iGO.

Install a cracked version first.

Hi Fatboyfun,
Thanks for the swift reply, it seems Becker a bit more on the ball than TT on this issue, Go satnav's were easy to crack and install with programs already made for these - install, put in meta txt press button done
Not so much luck with these as they seem to be model specific, which is a shame as their a good piece of kit
Oh well could always put new map on Xmas list from the missus.....

Any ideas on this would be appreciated;
OK here's the problem, satnav as posted above is all genuine, maps and software. Ive set TRUCK profile correctly and for all parameters needed. Simply drive down the road towards the nearest low bridge and bingo, it tries to take me under it. My truck is 4.56m in height, the bridge is 4.0m !!
I've also noticed when driving along certain routes where their are TRUCK Stops, which are listed as poi's on the satnav, I will ask the satnav to show me a list of TRUCK poi's on route - it will list them and then they will disappear off the list on screen...
Is this possibly a License issue or corrupted software; When I connect to Content Manager 2 it says everything is upto date and OK; Ive written to Becker but all I got was, either download a new map at £79 or send it off for repair !! - fat lot of help they were
Thanks in Advance.

With past mapsets there was an error in truck dimension calculations, I forget exactly which way round it was but either multiplying or dividing the length and height by three solved truck mis-routing.

I'll give it a shot, and see how we go